"Customer stated unit is not spinning clothes out. Checked and found no stored error codes. Ran rinse cycle and found when agitation began the control would go blank then start again after a few seconds. Verified proper voltage at control board. Discovered burning smell coming from control after motor has been running. Ordering control, motor and harness. Control is backordered.; ordrng 1 W11170317 (CNTRL- ELEC) and 1 W10890624 (DRIVE MOTOR) and 1 W11448788 (Harness)"

F4E3 sump and F7E1 heater error . Unit has 125 volts going to the unit when running . Control sending 79 volts to wash pump but not staying on .wash pump is turning on and off called tech SR 7733358628 said to order control and wash sump and going to change both at the same time . Ordering wire harness to have on hand as well . ; ordrng 1 W11085683 (pump&motor) and 1 W11305308 (Control) and 1 W10919642 (harns-wire)

"Replaced fill valve and water level switch for overfilling. Ran calibration, checks good."

"Replaced control for filling too much on delicate cycle. Unit still filling to deep fill level, ordering fill valve, and water level switch.; ordrng 1 WPW10414398 (Fill level switch) and 1 W11210459 (Valve)"

Replaced ui for erratic operation the washer tested good. ; dspstn on spec-tagged invntry: 1 W10911040 PANEL- CNTRL