"Replaced control panel. Put unit back together and tested touchpad. Interface responded to commands correctly and is now working properly.; O-emld tckt , states that autho needed"

Customer stated unit was giving her F2E1 error code for a stuck key. She reset the breaker and tried it again but when she did gave her same error code. I put unit into a diagnostic mode and did find that error code stuck. Ordering control panel.; ordrng 1 W11039015 (Console)

Replaced heating element. Put unit back together and tested it. Did not see any leaks unit is working properly.; dspstn on spec-tagged invntry: 1 W11537778 ELEMENT

Replaced lower oven control and appliance manager expansion module. Ran diagnostic no codes. Unit is operating as designed.

Customer states lower oven will not shut off. Ran diagnostic test. No codes. Ran upper and lower ovens. Lower oven stays on even when control says it's off. Until power is removed from unit. Ordering control and appliance manager expansion. ; ordrng 1 W11294389 (Appliance manager expansion) and 1 W11294388 (Control)