"Unit had pressure fault error code. I replaced the control board, ran a diagnostic cycle. Unit is working properly. Repaired covered under S153EB; dspstn on spec-tagged invntry: 1 W11603810 CNTRL- ELEC"

I started a bake cycle to confirm the knobs getting hot I did feel a lot of hot air escaping from the top of the door. When I pushed on door it sealed better and didnt let out much heat. I suggest replacing the door hinges to help pull door more towards the cavity and door seal as well. Case # 22211249; ordrng 2 WPW10440013 (Door hinges)s and 1 W11562931 (Door gasket)

Could not duplicate issue.

"Replaced upper spray arm and tested, working properly."

"Upper interlock stuck in service position. Possibly due to doors slamming. Customer agrees slammed door is possibility. Returned interlock to operational position and tested, unit working properly."