"Customer complaint unit isnt washing and is making loud sound during spin and agitate. Ran auto diagnostics. During agitation unit made loud grinding sound. Also makes noise during spin. Washplate is loose in unit. Removed washplate and saw splines on washplate and on gearcase shaft are badly worn so washplate just slips around shaft. Ordering gearcase, washplate, slider, Rotor and screw. ; rqstng P&A on 1 W11455453 (Gearcase) and 1 W10754161 (motor rotor) and 1 W10734521 (slider) and 1 W10902814 (washplate) and 1 W10625252 (screw)"

Ice maker is working . Humidity control was on but the mullion was loose and not staying on as it should fixed connection and is seated properly not . Unit tested good .

Freezer section frosted over . Called techline SR 7731864259 . Ohm out thermistor in glass of ice water . 8.7 Ohm at 32 degrees . Tested good . Techline said to replace main control in rear . . Ran test four and 3 way valve is working . Heater works . Defrosted unit . Ordering main control WPW10675033; ordrng 1 WPW10675033 (cntrl-elec)

Infinite switch for right front burner is bad causing the burner to always be on high when not in off position. Replaced infinite switch. Tested right front burner and is now working as expected. Unit tested good

Replaced main control for not starting dryer and just clicking. Same result. Calle tech line and found there was a loose connection at the motor that was causing loss of voltage and not starting motor. Tightened connection and the dryer is now working as expected.