Dispenser door wouldn't stay closed and top rack won't operate properly. Installed adjuster kit and new dispenser. Repair completed successfully.

Drain pump runs continuously when connected to power. Replaced control board then calibrated. Unit testing good.

Customer complaint was that water was spilling out of the ice maker whenever it went to make ice. I cycle the ice maker and as soon as it filled water was leaking out the front. Tested the valve and it seemed to open and close correctly with no problems and was not staying open for too long. I inspected the ice maker for any cracks that would cause leaks but could not find any so I reinstalled it and adjusted the level a little bit and then cycled it again and it filled with water but did not leak. If the leak comes back and customer calls then order it ice maker W10884390

Unit would fill and power would get down to the wash pump but it would not turn on. I replaced the wash pump and tested unit and unit works correctly with no leaks

Unit will not start a cycle and is throwing an f6 E1 error code indicating no response from acu board. UI lights up and is interactable but when you go to start a cycle you get no response from the ACU board. The ACU board hasn't arrived yet so I scheduled job for Wednesday 04/09; schdld next appmnt for 4/9 WED PM