Found unit hi limit fuse blew causing unit to lose power. I jumped fuse and turned unit on. Heating is working unit did unlock. ; ordrng 1 WB24X35587 (Hi limit fuse)

Sr 7741733551 inner tub does not lift up to disengage the tub causing the UL error code. I tried to clean off the bearing and gear case but I could not remove the inner tub as it had welded to the gearcase. Unit would need a new inner and outer tub plus a gear case so customer is not going

Refrigerator door gasket torn. Replaced gasket and heated into proper shape

Customer states that every load she gets a UL error code for an unbalanced load. I was unable to get unit to replicate the issue when I ran a load of towels through a drain and spin. The suspension rods seemed slightly weakened but not enough to throw the whole tub around from my observation. Customer requested that I changed the suspension rods so I did and I tested unit with a load of towels and there were no error codes The floor at the back of the washer seem to have some sort of water damage weakening the floor so I suggested to the customer that maybe if we move the washer forward on the more stable ground it would have better results but the room where the unit is is very small and she wanted to try it without moving it Forward first

"F6E6 and F6E9, communications error. Unable to start bake cycle in either oven. Cleared errors and tried again. Both ovens started and operated properly. Customer to monitor. If issues reappear, unit will need both boards replaced.; rqstng P&A on 1 W11179310 (Main Control) and 1 W10801665 (Lower control)"