"Customer stated that unit is still leaking a bit from the door. After inspecting unit i found that the spray arms tested bad. Replaced upper arm with retainer, middle and lower arms. Ran a diagnostic cycle in which the unit operated as intended. Unit tested good"

"Customer stated that the unit is not starting a cycle. Error code F3E2-pressure system fault. After inspecting the unit i discovered that the previous replaced control tested bad. Replaced control. Calibrated unit, ran a diagnostic cycle in which the unit operated as intended. I then started a cycle with a load of laundry in which the unit started with no issues. Unit tested good"

"Installed encoder, control and pump. After running a diagnostic i found that the drain pump still isnt receiving voltage. Ordering lower harness W11643701 and control W11513246; ordrng 1 W11643701 (Lower harness) and 1 W11513246 (Control)"

"Customer stated that unit is not starting a cycle. Error code F9E1-long drain. After inspecting unit i found a broken wire going to drain pump, i repaired the wire but i could not get the unit to drain as the drain pump is not receiving voltage from the control. Ordering control W11513246, encoder W11481116 and drain pump W11399437; ordrng 1 W11513246 (Control) and 1 W11481116 (Encoder) and 1 W11399437 (Drain pump)"

Replaced dispenser pads. Unit tested good