Replaced evap fan motor and control. Programmed control to code 01. I explained to the customer to give the unit 24 hours to get to temp. Unit tested good

Customer stated that unit is not cooling in FF compartment. Temps FF 58 and FRE 1.2. Evap fan and control tested bad. Ordering evap fan WPW10128551 and control WPW10503278; ordrng 1 WPW10128551 (Evap fan) and 1 WPW10503278 (Control)

Replaced condenser motor and fan blade. Unit tested good

Customer stated that unit is not completing a cycle. Error code F8E1-long fill. After inspecting unit i found debris in the water valve. Replaced valve. Calibrated unit. Ran a diagnostic cycle in which the unit operated as intended. Unit tested good

Customer stated that the unit would not complete a cycle. No codes. I ran a diagnostic cycle in which the unit operated as intended-after the unit threw a F6E3-communication error. I calibrated unit then the unit threw a F2E3-ACU/UI miss match. I replaced the control. Ran a another diagnostic cycle and calibration -both completed without throwing any codes. Unit tested good